How to Use
Step 1: Connect Your Device
Connect your Samsung device to your PC using a USB cable.
Ensure USB debugging is enabled on the device.
Verify the connection by allowing the device to authorize ADB commands when prompted.
Step 2: Launch the Tool
Run the Knox Guard Remover Beta V1.0.exe file on your PC.
The tool’s interface will open, displaying the current device status, logs, and controls.
Step 3: Check for Device
Click on the “Check Device” button.
The tool will scan for connected devices.
If no device is found: Ensure the device is connected, USB debugging is enabled, and try again.
If a non-Samsung device is detected: A message will appear indicating that the tool only supports Samsung devices.
If a Samsung device is detected: The status will update to “Samsung Device Connected.”
Step 4: Disable Knox Guard
Once the device is verified, the “Disable Knox Guard” button will become active.
Click this button to initiate the process.
The progress bar will indicate the current status of the operation.
Step 5: Monitor Logs
Logs will be displayed in the Logs Section during each step of the process.
You can clear the logs at any time by clicking “Clear Logs.”
Step 6: Complete the Process
Once the process is completed, the logs will confirm whether Knox Guard was successfully disabled.
If the process fails, detailed error logs will be available to help troubleshoot.
